<May 9, 2010>

Andair Fuel Pump Install Day 1

Tonight I continued with the Andair pump installation/modifications.



I cut the tab off of the cover as perscribed by the Andair plans.

Next I marked and cut the selector housing for trimming.

After measuring all this out very carefully, I marked and drilled the pump mounting plate to the tunnel cover.

Here's what it looked like with all the holes drilled, and the large hole for the fuel line cut into the cover.

I then clamped the angles I cut the other day into place and drilled them through the cover.

Here are the angles clecoed into place. I am a bit concerned about the amount of space the angles consume under the cover, so I am going to stop here and do a bit of research. Perhaps there is a better way of doing this.

I had some time so I took out my reamers and enlarged the holes in the Skins where the F-7114 Fuselage Gussets will attach.