<July 1, 2007>

Drilled Seat Belt Anchors

Now it was time to drill the F-634 Seat Belt Anchors to the F-705 Bar assembly. This only took me about an hour and a half to do.



First I marked and drilled all the left F-634s according to the dimensions on the plans.

I fabricated a 3/16" spacer from some scrap MDF and clamped the right anchors in place for drilling. I also used the shank of my 1/4" reamer through the bolt holes in the achors to make sure the holes that will take the bolt for the belts were properly aligned. Once everything was aligned and clamped, I flipped it over and drilled the right belt anchor(s).

Easy-peasy! They are all drilled and temporarily mounted.