<May 30, 2007>

Control Column Stuff - F-633s & WD-610

I picked up where I left off the other day by shaping the F-633s. They are thick, and it was a bit taxing on my small table-top band saw, but they are done. Once the F-633s were bolted into place on the bulkhead I spent some time installing the WD-610 Control Column.



With a little help from my friends the the band saw, belt sander and the deburring wheel, these came out great.

It took a few attempts to get the correct combination of washers in place, but I was able to get the WD-610 bolted into place. Thank goodness for washer wrenches!!!