<September 27, 2006>

Deburred & Dimpled Left Wing Skeleton

Busy week so far, not much time for building, but I will take what I can get. In the limited time I had tonight, I deburred and dimpled the top side of the left wing skeleton (ribs & rear spar), actually I deburred the entire wing but I only had time to dimple the top.



Yup, them ribs are dimpled!

After dimpling the rear spar, I used the countersink/deburring bit in my cordless screwdriver to clean-up the dimples a little. By "clean up" I mean countersink, but only slightly (a few turns) per the instructions. This will allow the skin dimples to sit better in the dimples of the rear spar.